Set up the microscope RS-232 communication to:
•Before DeltaPix InSight v6.1.18 : 9600, N, 8, 1, NoFlowCtrl .
•From DeltaPix InSight v6.1.18 : 9600, E, 7, 1 NoFlowCtrl (This is almost the default microscope setting)
See technical document 99MBA091A6 (31.05.2013) on how to configure the microscope.
•See page 1-11 on how to setup RS232 communication
•See page 1-13 on how to enter/exit setup
F07 Microscope Communication Setup
•F07-1 = 9600 baud
•F07-2 = 7 databits
•F07-3 = Even parity
•F07-4 = 1 stopbit
•F07-5 = Flowcontrol (xon/xoff) = OFF
•F07-6 = Flowcontrol (hw) = OFF
F03 Resolution setup
All axes, select the ０.1： Minimum readout of 0.1µm/0.00001”
RS232 Cable
Optionally use a USB-RS232 converter in the PC end.
Dataformat example
Query : "A"<cr><lf>
Response : "X +004.1880,Y +004.5870,Z +006.1523"<cr><lf>
will display:
