By attaching a dot- or bar-code to each objective position, it is possible to make the objectives encoded in a smart way.
The associated calibration will automatically be applied.
Just below the bar code button, the most recent read code is displayed, in this example "<2>"
Objectives are indexed 1..N, and the label for e.g. objective #3 should contain the string "<3>".
IMPORTANT: Objectives MUST be labeled in the same order as defined in the optics definition editor.
Codes are easily created on-line from this page : https://barcode.tec-it.com/en/QRCode
Code for 1st objective "<1>"
Code for 2nd objective "<2>"
Code for 3rd objective "<3>"
Code for 4th objective "<4>"
Code for 5th objective "<5>"
Code for 6th objective "<6>"